do not press the back button…
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
- Porsche 356B 1959-63
- Porsche 356C 1963-65
- Porsche 914 (1970-1976)
This banjo bolt is used to connect a brake line (via a banjo fitting) to the dual-circuit master cylinder on classic Porsche models. It fastens the brake line banjo fitting to the master cylinder and provides the internal fluid passage needed for brake hydraulic flow. A sound banjo-bolt connection supports firm pedal feel and dependable braking performance.
Sold each, 2 pieces needed per car
Fits:
Porsche 356 B/C 1.6L 01/1959 - 12/1965
Porsche 914 1.7L-2.0L 01/1969 - 02/1976
Diagram ref no 41
Installed at the master cylinder brake outlet, the banjo bolt clamps the banjo fitting in place and allows brake fluid to pass through its drilled channels under pressure. Because it sits in a high-pressure circuit, correct fit and condition are essential for leak-free operation.
Old banjo bolts can corrode, round off, or suffer sealing-surface wear, which increases the risk of brake fluid leaks and loss of hydraulic pressure. Replacing with a fresh bolt helps restore a secure connection and supports safe, reliable braking.
When to replace:
• Brake fluid seepage around the banjo fitting/master cylinder
• Corrosion, damaged threads, or rounded bolt head
• During master cylinder replacement or brake line refurbishment
• When rebuilding a classic brake system using new lines/fittings
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
69535153401
The product you are viewing cross references to these numbers
.jpg){kind=link}
Hydra tec lubricant for maintenance work and protection Textar
Available in 75ml Tube or 5ml Sachet
The Advantages of Hydra Tec:
- Facilitates the installation of hydraulic brake components
- Tested compatibility with commercially available braking fluids (DOT3, DOT4, DOT4LV, DOT5.1)
- Free of mineral oils and compatible with EPDM rubber
- In addition, running surfaces are protected against corrosion
Hydra Tec is suitable for lubricating:
- Cylinder running surfaces
- Pistons
- Sealing elements
Application:
Apply a thin layer of Hydra Tec on the marked sections.
Note:
Hydra Tec should be applied thinly and evenly.
Never use mineral oils or greases as substitutes.
Do not apply the product on friction surfaces of brake pads or brake discs.
Find out about Textar product verification here