Please wait… 
Please wait while we process your order,
do not press the back button…
do not press the back button…
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
Category Filter
Rennline Rear Subframe Stabilizer with Tie Downs (Front & Rear). Porsche 981 Boxster / 981 Cayman - E3647SB97
E3647SB97
Vehicle Group
- Porsche Boxster 981 2.7L 2012-16
- Porsche Boxster 981 S / GTS 3.4L 2012-16
- Porsche Cayman 2.7L 981 2013-16
- Porsche Cayman S / GTS 3.4L 981 2013-16
- Porsche Cayman GT4 3.8L 2015-16
Information
Rennline Rear Subframe Stabilizer with Tie Downs (Front & Rear).
Fits:
Porsche 981 Boxster
Porsche 981 Cayman
Subframe Stabilizer:
Most Boxster and Cayman owners who take their cars to the track, have equipped their Porsches with tires much wider and stickier than stock, which allows higher g-forces to be achieved in cornering and braking. During that type of hard driving, the 2 piece rear sub frame flexes by the extreme loads being put on them, defeating your car's finely tuned alignment settings, thereby reducing your braking and cornering potential, and increasing tire wear. With this install, your Porsche will handle and brake with greater precision, predictability, and feedback to the driver. Comes with integrated rear tie down brackets and hardware for a 10 minute installation.
Front Tie Downs:
Securing a 981 to a trailer is next to impossible without the use of wheel straps that are just about guaranteed to destroy your wheels in time. Save those expensive wheels with a set of inexpensive tie down hooks from Rennline. These hooks have been specifically engineered to bolt to the front of your car without any modification or removal of any factory torqued bolts. Additionally, Rennline has incorporated a much needed jack pad into the front tie downs that will allow you to easily lift the front of your car without the worry of damaging your rocker panel or plastic under trays. Hooks are constructed of steel and powder coated red.
Rear Tie Downs:
These hooks have been specifically engineered to bolt to the rear of your 981 and come with any necessary hardware and installation instructions. Hooks are constructed of steel and powder coated red. Each kit comes with (2) rear hooks.
Note: Pictures may not show actual product.
Fits:
Porsche 981 Boxster
Porsche 981 Cayman
Subframe Stabilizer:
Most Boxster and Cayman owners who take their cars to the track, have equipped their Porsches with tires much wider and stickier than stock, which allows higher g-forces to be achieved in cornering and braking. During that type of hard driving, the 2 piece rear sub frame flexes by the extreme loads being put on them, defeating your car's finely tuned alignment settings, thereby reducing your braking and cornering potential, and increasing tire wear. With this install, your Porsche will handle and brake with greater precision, predictability, and feedback to the driver. Comes with integrated rear tie down brackets and hardware for a 10 minute installation.
Front Tie Downs:
Securing a 981 to a trailer is next to impossible without the use of wheel straps that are just about guaranteed to destroy your wheels in time. Save those expensive wheels with a set of inexpensive tie down hooks from Rennline. These hooks have been specifically engineered to bolt to the front of your car without any modification or removal of any factory torqued bolts. Additionally, Rennline has incorporated a much needed jack pad into the front tie downs that will allow you to easily lift the front of your car without the worry of damaging your rocker panel or plastic under trays. Hooks are constructed of steel and powder coated red.
Rear Tie Downs:
These hooks have been specifically engineered to bolt to the rear of your 981 and come with any necessary hardware and installation instructions. Hooks are constructed of steel and powder coated red. Each kit comes with (2) rear hooks.
Note: Pictures may not show actual product.
Price: €513.63
Orderable
Related products
Information
Rennline Race Hook. UNIVERSAL
5, 6 or 7 inch.
Rennline's steel tow hooks are precision machined and will stand up to the extreme abuse seen in any race environment. These pulls have a 2" opening as required by most organized race events.
Note: Pictures may not show actual product.
5, 6 or 7 inch.
Rennline's steel tow hooks are precision machined and will stand up to the extreme abuse seen in any race environment. These pulls have a 2" opening as required by most organized race events.
Note: Pictures may not show actual product.
Prices from: €71.60
Information
Rennline Tie Downs. UNIVERSAL
SET OF 2
Rennline's tie-down brackets are made of either stainless steel, or mild steel in red powdercoat. These brackets are available in four variations: straight, 90°, 66°, and 45° to allow you to install these brackets in many different locations based on your specific needs. Mounting hole measures 16.5mm. This is the same dimension as most shock mount bolts and several other suspension components.
The 66° tie downs are designed specifically for 996/997 with upgraded rear sway bars. GT2 and GT3 cars will also use the 66° tie down.
Note: These come in sets of 2
Note: Pictures may not show actual product.
SET OF 2
Rennline's tie-down brackets are made of either stainless steel, or mild steel in red powdercoat. These brackets are available in four variations: straight, 90°, 66°, and 45° to allow you to install these brackets in many different locations based on your specific needs. Mounting hole measures 16.5mm. This is the same dimension as most shock mount bolts and several other suspension components.
The 66° tie downs are designed specifically for 996/997 with upgraded rear sway bars. GT2 and GT3 cars will also use the 66° tie down.
Note: These come in sets of 2
Note: Pictures may not show actual product.
Prices from: €60.02
